Differences

This shows you the differences between two versions of the page.

--- archive:nmk322 [2024/12/10 10:57] – [Library Codes] azman
+++ archive:nmk322 [2025/10/01 07:31] (current) – [Lecture Slides] azman
@@ Line 9: / Line 9: @@
 [20241017] Updating this for 202425s1 Academic Session.
-===== Lecture Slides =====
-  * Lecture 1 - {{:archive:nmk322:lecture01_overview.pdf|Overview}}
-  * Lecture 2 - {{:archive:nmk322:lecture02_arch8051.pdf|Architecture}}
-  * Lecture 3 - {{:archive:nmk322:lecture03_c8051.pdf|C for 8051}}
-  * Lecture 4 - {{:archive:nmk322:lecture04_gpio.pdf|8051 I/O}}
 ===== Library Codes =====
@@ Line 20: / Line 14: @@
 Introduction to using 'library' code. Single header include file(s) meant for single source compilation. These are meant to be compiled using Keil 8051 compiler.
-I recommend to use my include file ({{:archive:nmk322:my1code51inc-20241210.zip|mcu51.h}}) rather than the regular (reg51.h) because it would be easier for you to use my example codes and library. I wrote and tested them using my own syntax that can be used on both Keil and SDCC compilers.
+I recommend to use my include file (mcu51.h) rather than the regular (reg51.h) because it would be easier for you to use my example codes and library. I wrote and tested them using my own syntax that can be used on both Keil and SDCC compilers. Simply extract this {{:archive:nmk322:my1code51inc-20241210.zip|zip file}} and setup the include path. Ask me during lab session if you do not know how to do that.
 ==== Library: Serial (UART) ====